I have a thang for vintage lamps because they are fabulously unique. My obsession with them began in college when I stumbled upon a pair of orange-globed wonders at Goodwill for $3 a piece. (If you are ever in need of a fun, kooky light, go to Goodwill. Always.) Even though I take pride in my collection, these older models come with one BIG problem:
These bad boys have equal-sized prongs that do not distinguish between the hot and neutral wires.
Translation: Greater risk for electrical shock!
Solution: A lamp kit!
Lamp kits can be found at almost any hardware store, and they cost around $10–a small price for safety. Rewiring a lamp is not difficult, but it can be a little cumbersome if you are working with a model that has a lot of odd parts. Here is how I did it…
How to Rewire An Old Lamp
Step 1: Remove the old lighting system
Using wire cutters, cut the electric cord at the bottom of the lamp. (Some lamps come with a velvet or paper cover at the bottom of the body. Pull back to expose the cord.)
Carefully pull lighting system out and discard.
Step 2: Disassemble lamp and TAKE PICTURES!
Carefully disassemble the lamp, making sure to line up all of the pieces in the order they were assembled in. Now, take a photo of the lamp parts all laid out–you will need this for reference later!
Step 3: Make any cosmetic adjustments
I decided to give my lamps a make-over with a coat of white paint. For best results, sand and prime metal parts before painting.
Step 4: Feed the new lighting cord up through the lamp’s pipe
Push the cord up through the pipe until it comes out the other end:
Step 5: Reassemble lamp body and neck
Here is where those pictures you took earlier will come in handy!!
Step 6: Screw harp base onto the pipe
Step 7: Disassemble the new socket
Step 8: Screw the bottom half of the socket onto the pipe and secure
Step 9: Expose and loosen terminals on the top half of the socket
Gently push up the socket cover to expose the terminals. These screws are where you will attach the cord’s wires.
Loosen the terminals to allow room to wrap the wires.
Step 10: Tie cord into an “electrician’s knot”
An electrician’s knot acts as a buffer against any strain put on the wires once they are attached to the terminals. For example, if the lamp cord were to get yanked by accident from the bottom, this knot would absorb the tension allowing the wires to remain in place safely around the terminals. As a result, this knot offers further protection against electrical shock.
To make the knot, use this photo as a guide:
Step 11: Locate ribbed wire on the cord and wrap around suggested terminal
Of the two wires that compose the electric cord, locate the one that has a ribbed plastic coating.
The instructions on your lamp kit will tell you which color terminal to wrap this ribbed wire around. In my case, I needed to wrap the ribbed wire around the silver terminal.
Step 12: Tighten terminals to secure wires
Make sure the wire is snug and fully wrapped around the base of the terminal. Carefully tighten into place. Repeat with other wire.
Step 13: Snap the top half of the socket onto the bottom half
Double check to see if knot/wires are secured in place.
When all is ready, snap the top half of the socket onto the bottom half.
(If for any reason you need to remove the top of the socket, carefully use a flathead screwdriver to pop it out of place.)
Finally, screw in a light bulb, plug the lamp in and let there be light!
Here is how my vintage lamp looked before its makeover:
And here is how it (and it’s twin) look after:
I am thrilled with the final results. Now my lamps are prettier and safer for use. Success!